|
What do you do when the vocalist gives you the nod for that lead-break when you're not expecting it? .
The AUTOLYCUS PEDAL A footpedal-switch toggles a 'normal' volume level which is set at the main amplifier, and a preset higher volume as required for that 'lead-break'. The higher volume is set on the pedal up to a maximum signal voltage gain of approximately times 3. The input impedance is nominally 1Mohm to suit the needs of high impedance pickups, and particularly the Autolycus pickup. The output impedance is low and will feed almost any normal amplifier input. The housing is robust and virtually unbreakable. Battery life is LONG. 9v internal. Current drain 240 microamps-LED off. LED on, less than 1.5mA. The 'LED' is only to indicate high volume toggle. The output jack is the switch. Battery life can extend to years rather than months under average usage especially if the LED is not on for long periods. The battery supply is disconnected when the output jack is removed. The input cable is integral with the housing. Setting up hints: Make all connections (with the main amp volume low). With the PEDAL' LED' off adjust "normal" volume levels and tone on the main amplifier. Then toggle the LED on and preset the higher volume level. A dab of the foot can now assist that lead-break whilst playing.The advantages of this pedal will be realized by all who play electric fiddles. No attachments to the player are needed. Good freedom of movement is maintained. The RCA connectors do not appear to pull apart under normal playing. I have not experienced this in over six years of playing. In the miserable event however, that someone's foot hooks a cable, it might be hoped it would pull free and reduce/ avoid damage. The optimum electrical match for piezo pickups is achieved with this pedal/ preamp and the fixed input cable length into the preamp minimises further signal degradation. Individual preferences vary, don't be afraid to experiment. Use tone controls provided on main amplifiers. A short echo can be useful to enhance tone and volume as a preference. This pedal may be fitted with a standard 1/4 inch jack plug. It can enhance the performance of almost any high impedance transducer including those for guitars. No liability for damage will be accepted from the use of this product. |
||||||
|
Fiddlesource/Autolycus USA is the exclusive US Disributor of Autolycus Products |
||||||
|
||||||